tracking

Circuit Boards
Get your circuit boards dust-free.
WHAT YOU NEED

1x

WD-40 Specialist® Contact Cleaner

INSTRUCTIONS
1.
Remember to switch off all electrical equipment and let the hot surface cool down before the cleaning process. Safety is key!
2.
Hold the circuit board or any other electrical appliances about 15 - 20centimetres away and spray a generous amount of WD-40 Specialist® Contact Cleaner onto the surface.
3.
Let the solution sit for a couple of seconds until it is completely dry.
Tip! To check if it is dry, use the tip of your finger to lightly dab the surface to see if any remnants will stick to your finger.
4.
Check if the parts are all clean and repeat if necessary before inserting them back into place, for dust-free circuit boards!
Pro Tips!
You can also use the WD-40 Specialist® Contact Cleaner on any electrical equipment and contacts with a dielectric strength of 35000 volts. Likewise, you may use it for fuse blocks and electrical connectors.
WD-40® Fan Club
Love WD-40® Brand Products? Join the club!
Ooops!
Generic Popup