HOME
FAQS
VIDEOS
SDS/TDS
電路板
讓您的電路板一塵不染
您需要
1x
WD-40 Specialist® Contact Cleaner
WD-40 專業系列® 精密電器清潔劑
使用方法
1.
切記在清潔流程前關閉所有電氣設備,並讓發熱表面冷卻。安全至關重要!
2.
將電路板或其他電器放在 15 至 20 厘米處,在其表面噴灑大量 WD-40 Specialist® Contact Cleaner(WD-40 專業系列®
精密電器清潔劑)。
3.
讓溶液靜置數秒,直至完全變乾。
小提示!如要檢查是否變乾,請使用指尖輕觸表面,看看是否有殘留物粘在手指上。
4.
檢查零件是否乾淨。如有需要,在插回原位前重複步驟,以獲得無塵電路板!
專業小貼士!
您亦可在介電強度為 35000 伏特的任何電氣設備和触點上使用 WD-40 Specialist® Contact Cleaner(WD-40 專業系列® 精密電器清潔劑)。
同樣,您也可將其用於保險絲盒及電子連接器。
FAQs
FREQUENTLY ASKED QUESTIONS on WD-40
®
Contact Us
Careers
SDS / TDS
Investor Relations
Privacy Notice
COOKIES POLICY
Terms of use
Sitemap
© WD-40 COMPANY (MALAYSIA) SDN BHD. All Rights Reserved
WD-40
®
is a registered trademark. Multi-Use Product is the product category. For simplicity on this website, WD-40® Multi-Use Product is sometimes shortened to WD-40
®
About WD-40
®
BRAND TRADEMARK
Many of the uses of WD-40
®
Multi-Use Product and WD-40
®
Specialist
™
products described on this website were provided to WD-40 Company by end-users of the products, and do not constitute recommendations or suggestions for use by WD-40 Company. These uses have not been tested by WD-40 Company. Consumers should exercise common sense whenever using WD-40 Company products. Always follow the instructions and take heed of any warnings printed on packaging.
About WD-40
®
BRAND USES
WD-40
®
Fan Club
Love WD-40
®
Brand Products? Join the club!
Join WD-40
®
Fan Club
Ooops!
Generic Popup